To calculate the reduced load capacity at a load center greater than the standard 24 in (61 cm) load center, multiply the zone capacity from the load chart by the appropriate reduction factor listed in the table below:.Keep the load centered on the fork carriage. Note that this does not account for a load center that is not centered between the forks or a vertical load center exceeding 24 in (61 cm) from the top face of the fork tine.For loads with a load center exceeding this value, operators need to determine the reduced load capacity for a specific load zone. All Genie ® telehandler fork carriage load charts are based on a horizontal load center that is 24 in (61 cm) from the front vertical surface of the fork arm.Fork length should always be at least two-thirds the load length.Always center the load on the forks and position the load so that it is completely against the back of the fork frame.Here is some information for accurately calculating a telehandler’s lift capacity and applying what is outlined in the unit’s load charts: Tips for applying the telehandler’s load chartįor safe use and productive operation, it is important that operators understand the telehandler’s load chart and how to apply that information to the jobsite’s needs. Be sure to look at the telehandler’s load chart that corresponds with the attachment being used before starting work. fork, bucket, carriage or work platform) will also impact the telehandler’s load capacity, load height and reach. And, don’t forget that the telehandler attachment (e.g. It is important when checking out a telehandler’s load chart to look at weight lifting capacity, but operators also need to look at where the telehandler can lift that weight.

A peek at a telehandler’s load chart will tell an operator a lot about how much the machine can do, such as how much it can lift, how high it can lift the load and at what angle. Like many aerial devices, telehandlers are rated for their load capacity, height and outreach. Because of these machines’ ability to do so many jobs, they have become a staple on construction and landscaping projects. Telehandlers offer operators loading and unloading capabilities, as well as the ability to move and place heavy loads like steel, masonry and bricks. When the job calls for lifting, moving and placing materials on jobsites, telehandlers are a great go-to equipment choice, because these machines can complete all those tasks with just one unit - as opposed to needing a combination of machines, such as a skid steer loader, forklift, and small crane to complete a job.

Excavator load chart